Categories
Contact Us

Linhai Zhengda Machinery Co.,Ltd
Add: No.261, Hushan South Road, Xiaozhi Town, Linhai City, Zhejiang Province, China
Contact: Kevin
Tel: +86-576-85889981
Mob: +8613666497878
E-mail: zhengda@cnzdkj.com

News
Home > News > Content
Main Points Of Assembling Stone Edging Machine
Dec 23, 2017

The assembling of the stone edging machine must be operated according to the requirements of the Assembly technology, but the different assembling technical requirements are not the same, but there are many working points in the assembly process that must be observed together.

1. Do the cleaning and cleaning work of parts, including removing residual casting sand, rust, chips, etc., especially some important parts.

2. Matching surface in conjunction with or connect before, generally need to add lubricants, especially the spindle box parts in the bearing parts, lifting mechanism of the screw nut parts.

3. Match the size of matching parts to be accurate, assembly of the matching size should be retest or sampling, such as: the spindle of the shaft neck and the bearing with the location of the spindle box and bearing with the hole and its center distance.

4. The assembling of the stone grinding machine wheel requires that the axis line of the two-tooth wheel must be in the same plane and parallel to each other, and the normal tooth-closing clearance should be ensured and the axial dislocation ≤2mm.

5. The joint surface should check whether the formation, there is no deformation, or should be trimmed, remove burrs, to ensure jointing contact Close, flat, not askew.

6. Seals should be pressed in parallel to the seal groove, not distorted deformation, damaged scratches sealing surface.

7. Pulley assembly requirements are two pulley axes must be parallel, the wheel Groove Center should be positive, offset the General Assembly to make the belt pulley tension uneven, resulting in belt slippage and accelerated wear, at the same time V assembly should be matched, the length should be consistent, to prevent vibration in the transmission.

8. Bearing assembly should be cleaned before the cleaning paint can be assembled, cleaning should pay attention to check the raceway and rolling body has no rust, rotation is flexible, bearing assembly should be coated with a layer of lubricant on the surface of the assembly, if the pressure difference is found to be too large, should stop assembly for inspection, bearing assembly, no model of one end should be stone edging machine facing, Depending on the direction of the shaft, the set of bearings when the larger, the direction, position should be appropriate, should not make raceway this rolling force, should be evenly symmetrical beat, not hit, to ensure that the end and axis perpendicular to prevent the installation of tilt.


  • Newsletter
  • Categories
  • Contact Us

    Linhai Zhengda Machinery Co.,Ltd
    Add: No.261, Hushan South Road, Xiaozhi Town, Linhai City, Zhejiang Province, China
    Contact: Kevin
    Tel: +86-576-85889981
    Mob: +8613666497878
    E-mail: zhengda@cnzdkj.com

  • QR Code
  • Copyright © Linhai Zhengda Machinery Co.,Ltd All Rights Reserved.